CHAPTER 2: GETTING STARTED 5
Powering Down the Load Equipment Follow the steps below to turn OFF the output of the UPS and power down the load equipment.
>Control Logging
Status Display
Setup Diags
Accessories Help
>Turn Load Off
Do Self Test
Simulate Power Fail
Graceful Reboot
Confirm:
Turn UPS OFF
NO, ABORT
> YES, Turn UPS OFF
UPS HAS BEEN
COMMANDED TO TURN
LOAD POWER OFF
UPS LOAD IS OFF
Press any key...
1. Use ‘ESC’ to view to Main Menu , and then
select CONTROL.
2. Select the TURN LOAD OFF command.
3. Confirm choice by selecting YES .
4. You will hear some clicking sounds and see
message .
5. In approximately 30 seconds, you will see
message , and the green LOAD ON status
indicator will be OFF.
The output is now OFF.
6. To fully power down the UPS, turn OFF the
System Enable switch, and open the input
circuit breaker.
Do not install battery modules
until you are ready to power up
the UPS. Batteries can be
permanently damaged if loaded
prematurely.