Cable Connections to Other Devices
Using the Local Management Port
To connect the hub to a modem, do the following:
1 | Connect the modem only to the end hub. | |
2 | Set DIP Switch 2 UP for this hub.You will not be able | |
| to manage this hub using AsantéView | |
| the AMS Link while this switch is in the UP position. | |
3 | Set up the modem for | |
|
|
|
You can use the RS232 connector on the NMM as a local manage- ment port.This section describes the steps involved.They are:
❏Preparing the hub
❏Connecting to the local management port
To prepare the hub for communication via the local management port:
1 | Set the hub’s DIP Switch 2 DOWN as shown in | ||||||||
| Figure 8. |
|
| ||||||
DIP Switch 1 |
| DIP Switch 2 | |||||||
ASANTEVIEW |
| ||||||||
| RS232/AMS LINK | ||||||||
TERMINATION |
| CONFIGURATION | |||||||
|
|
|
|
|
|
|
|
| Set to |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| DOWN position |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| (DOWN = SETUP) |
|
|
|
|
|
|
|
|
|
|
Figure 8 RS232/AMS Link Configuration DIP Switch Setting
DIP Switch 1 can be set to either UP or DOWN.
2 | Reset the hub after changing the DIP switch setting by | |
| pressing the Reset button on the NMM front panel. | |
|
|
|
Follow these steps to connect an RS232 cable to the local manage- ment port.
Page 17
