5.4.6 PCIPnP

This menu shows the PCIPnP configuration settings. Select an item then press <Enter> to display a pop-up menu with the configuration options.

PCIPnP

Select Menu

Reset Configuration Data

[Disabled]

Resources Controlled By

[Auto]

IRQ Resources

 

PCI/VGA

Pallete Snoop

[Disabled]

INT Pin

1

Assignment

[Auto]

INT Pin

2

Assignment

[Auto]

INT Pin

3

Assignment

[Auto]

INT Pin

4

Assignment

[Auto]

INT Pin

5

Assignment

[Auto]

INT Pin

6

Assignment

[Auto]

INT Pin

7

Assignment

[Auto]

INT Pin

8

Assignment

[Auto]

Item Specific Help

Default is Disabled. Select Enabled to reset Extended System Configuration Data (ESCD) upon exiting Setup, if you installed a new add-on card and the system cannot boot due to a serious conflict in system configuration.

Reset Configuration Data [Disabled]

Allows you to enable or disabled resetting of the Extended System Configuration Data (ESCD) when you exit the Setup. The ESCD includes information on non-PnP devices. Set this item to [Enabled] if you installed an expansion card that conflicts with other devices and cause system boot failure. Configuration options: [Disabled] [Enabled]

Resources Controlled By [Auto]

When set to [Auto], allows BIOS to automatically configure of all boot and Plug and Play devices. When set to [Manual], you can assign the available IRQ Resources to the PCI devices. Configuration options: [Auto] [Manual]

When the item Resources Controlled By is set to [Auto], the item IRQ Resources is grayed out and not user-configurable. Refer to the section “IRQ Resources” for information on how to enable this item.

PCI/VGA Pallete Snoop [Disabled]

Some non-standard VGA cards, like graphics accelerators or MPEG video cards, may not show colors properly. Setting this field to [Enabled] corrects this problem. If you are using a standard VGA card, leave this field to the default setting [Disabled]. Configuration options: [Disabled] [Enabled]

5-28

Chapter 5: BIOS setup