To install a 600 W single power supply module:

1.Firmly hold the power supply module and insert it into the power supply cage.

2.Push the power supply all the way in until its outer end aligns with the rear panel.

Be careful with the power supply cables when inserting the power supply module into the cage. Due to space constraints, the cables may get entangled with the installed components or other cables, causing the cables to break!

3.Place the metal plate flat on the outer end of the power supply module, flushed to the top of the chassis, while matching the four hooks with their corresponding holes on the rear panel.

Hook matched to a hole

4.Hold the metal plate bar and push it upward to lock the hooks to their holes. At the same time, you may also push the top of the metal plate to fit it completely.

5.Secure the metal plate with the thumb screw.

2-54

Chapter 2: Hardware setup