2.10.7 Power suppy modules

The barebone server system power supply modules come in three configurations:

600 W single

2 x 300 W dual

3 x 300 W redundant

power supply

power supply

power supply

(110 V / 220 V autoswitch)

(110 V / 220 V autoswitch)

(110 V / 220 V autoswitch)

Refer to this section when removing or installing power supply modules to the barebone system.

You MUST disconnect all power cable plugs from the motherboard and other installed devices before removing the 600 W single power supply.

The picture below shows the motherboard and device connectors where the power plugs are connected. Refer to the Appendix at the end of this document for the power supply specifications.

4

2

3

5

1

6

124-pin ATX (motherboard power connector)

28-pin +12V (motherboard power connector)

32 x 4-pin plugs (SCSI/SATA backplane; hidden)

44-pin plug (optical drive)

54-pin plug (floppy disk drive; hidden)

62 x 4-pin plugs (second SCSI backplane, if available; hidden)

2-52

Chapter 2: Hardware setup