3.Attach Rail 2 to the other side of the drive as shown. The rail end should be on the side of the drive connectors.
Rail handle Hole 1 | Hole 3 | Drive connectors |
4.Check the HDD jumper setting. Refer to the label pasted on the HDD for the description of jumper settings. The setting “Cable Select” is recommended.
5.Carefully insert the drive into a bay on the front panel.
6.Push the drive all the way to the depth of the bay until the rail locks clicks, indicating that the drive is securely in place.
7.Connect the IDE and power cables to their corresponding connectors on the back of the drive.
8.Follow steps 2 to 6 if you wish to install other hard disk drives.
9.
Chapter 2: Hardware setup |