If the caller’s name or phone number is not displayed during Call Waiting:
• You should call your service provider to confirm that you subscribe to
a combined Caller ID with Call Waiting service.
• The screen may not display the call information if someone is on an
extension phone.
• The Caller ID with Call Waiting feature is inactive during a power
interruption.
• Make sure the battery is charged.
• Make sure Caller ID with Call Waiting is turned on (follow the
instructions under “Caller IDFeature Setup” in the FEATURE SETUP
section of this manual).
If speakerphone conversation sounds distorted:After the phone is powered up,the speakerphone initializes for about 10–15
seconds the first time it is used. Conversation should be clear after this.
If messages are incomplete:•If a caller leaves a very long message,part of it may be lost when the
system disconnects the call after three minutes.
• If the caller pauses for more than seven seconds,the system stops
recording and disconnects the call.
• If the system’s memory becomes full during a message,the system
stops recording and disconnects the call.
If you have difficulty hearing messages:Check the volume setting.
If the system does not answer after the correct number of rings:• Make sure that the two-digit message window in the base is on. If it is
off,press 0[ON/OFF].
• If Toll Saver is on,the number of rings changes to two when you have
new messages waiting.
• In some cases,the system may be affected by the ringing system used
by the local telephone company.
• If the memory is full or the system is off,the system answers after
10 rings.
IN CASE OF DIFFICULTY
48
9370_to make pdf_1ATT 6/12/00 2:07 PM Page 48