KM0832 User Manual
Invoking Auto Scan
To start Auto Scanning, key in the following hotkey combination:
1.Invoke Hotkey mode (see p. 123).
2.Press [A].
After you press A, you automatically exit Hotkey mode, and enter Auto Scan mode, and Auto Scanning begins.
While you are in Auto Scan mode, you can pause the scanning in order to keep the focus on a particular KVM port either by pressing P or with a
Pausing and exiting are the two ways to stop scanning and keep the focus on a particular KVM port. If you intend to continue scanning after a brief stop, pausing is more convenient than exiting Auto Scan mode completely.
This is because when you resume scanning after pausing, you start from where you left off. On the other hand, if you exit and then restart Auto Scan mode, you start over from the very first KVM port on the installation.
To resume Auto Scanning after you pause, press any key or
While you are in Auto Scan mode, you can press the arrow keys to skip through the OSD list:
←Switches to the previous KVM port in the OSD list.
→Switches to the next KVM port in the OSD list.
↑Switches to the first KVM port in the OSD list.
↓Switches to the last KVM port in the OSD list.
After the amount of time set with the SCAN INTERVAL elapses, Auto Scan mode will switch to the next KVM port.
When you skip, you only skip to the previous or next available KVM port that is in the Auto Scan mode selection (see p. 108).
While Auto Scan mode is in effect, ordinary keyboard and mouse functions are
126