Chapter 1. Introduction
Components
Front View
1
234 56
No. | Item | Description |
|
|
|
1 | Port LEDs | The Port LEDs provide status information about their |
|
| corresponding AC outlet ports. There is one pair of LEDs for each |
|
| port. The one on the left is the Remote Access LED; the one on |
|
| the right is the Power LED: |
|
| A Remote Access LED lights GREEN to indicate that the device |
|
| attached to its corresponding port is capable of being controlled |
|
| remotely. |
|
| A Power LED lights ORANGE to indicate that there is electricity |
|
| going to its corresponding outlet. The LED flashes under the |
|
| following conditions: |
|
| If Modem Ring Resume is enabled (see Modem Ring |
|
| Resume*, page 39), the outlet still receives electricity even |
|
| when it is OFF. The Power LED blinks OFF, then ON for 8 |
|
| seconds, then repeats this sequence to indicate this |
|
| situation. |
|
| When a power status change is pending, the LED flashes |
|
| until the change has taken place. |
|
| If both LEDs flash it indicates that there is either an overcurrent |
|
| situation, or the relay has failed. See Flashing Lightbulb, |
|
| page 33, for more details. |
|
|
|
2 | Firmware | During normal operation this switch is in the NORMAL position. |
| Upgrade | The RECOVER position is used when performing a firmware |
| Switch | upgrade. See Upgrading The Firmware, page 53, for upgrading |
|
| details. |
|
|
|
|
| (Continues on next page.) |
5