Chapter 8.

Administrator Login Failure

If you are unable to perform an Administrator login (because the Username and Password information has become corrupted, or you have forgotten it, for example), you can clear the login information with the following procedure:

1.Power off the PN0108 and remove its cover.

2.Short the jumper labeled J4.

Default

Password

J4

3.Power on the switch.

4.Wait 5 seconds, then power off the switch.

5.Remove the jumper cap from J4.

6.Close the housing and start the PN0108 back up.

After you start back up, you can use the default Username and Password to log in (see page 63).

63