For Windows | Atlantis Land Network Router guide

Chapter 3 Installation and Configuration

9.After installing the driver, follow the section “3.2 Configuring the Network Properties” below to modify the network settings on your PC.

3.1.2 For Windows 2000

1.When Windows tells you that the new device has been detected, click “Next >” to continue.

2.Select “Search for a suitable driver for my device”. Click “Next>”. Then, insert the installation CD into the CD-ROM drive.

3.In next window, check “Specify a location” and click “Next>”. Click “ Browse “ and specify the folder CD:\A02-WRA-11B\Driver\.

13

Image 19

Atlantis Land Network Router manual For Windows

Contents

Fly Wireless Router Adsl Page Copyright Page Table of Contents Chapter Fly Wireless Router Adsl Introduction An Overview of I-Fly Wireless Router Adsl Adsl Modem/Router Features Package Contents Introduction Hardware IndicatorsLED Indicators Front Panel Link/Act Rear PanelRxD 10/100 Jack ResetSwitch LineRJ11 Connect Router to LAN Hardware InstallationPower on Adsl connection Cabling Using Adsl Modem/Router Fly Wireless Router Adsl For Windows XP Installing the USB Driver Fly Wireless Router Adsl Installation and Configuration Fly Wireless Router Adsl For Windows Fly Wireless Router Adsl For Windows Me Fly Wireless Router Adsl For Windows Fly Wireless Router Adsl Configuring the Network Properties LAN Area Connection Status window, click Properties Click OK to finish the configuration For Windows Click OK to finish the configuration For Windows 95/98/Me Installation and Configuration For Windows NT4.0 Password Factory Default SettingsLAN and WAN Port Addresses For BT VPI=0, VCI=38 and for KC VPI=1, VCI=50 Information from ISP Configuring with Web Browser Fly Wireless Router Adsl Status Home Click Show Advanced settingsStatus Adsl Status Status LAN Configuration WAN Configuration System Wide Settings Encapsulation Service Category Select UBR or CBR Configuration LAN Configuration Subnet Mask Default at Fly Wireless Router Adsl IP Address Default at Configuration NAT Configuration Ethernet Mode Setting Fly Wireless Router Adsl Configuration Virtual Server Configuration Configuration- Wireless Installation and Configuration Configuration Bridge Filtering Configuration Configuration DNS Configuration Admin Privilege WAN Status Configuration Save Settings Admin Privilege PPP Status Admin Privilege TCP Status Admin Privilege Route Table Admin Privilege Adsl Configuration Admin Privilege Learned Bridge MAC TableTrellis Default at Enabled Admin Privilege RIP Configuration Admin Privilege Miscellaneous Configuration Admin Privilege Password Configuration Dhcp Target IP Igmp Proxy Default at Disabled Admin Privilege Diagnostic Test Admin Privilege Reset to Factory Default Checking LAN Connection Testing Ethernet LAN connection Test PPPoE connection Admin Privilege Network Code Image Update Admin Privilege Code Image Update Admin Privilege System Log Problem Corrective Action Problems Starting Up the Adsl RouterProblems with the WAN Interface Problems with the LAN Interface Troubleshooting Problems Connecting to a Remote Node or ISP Operating Temperature Power AdapterPhysical Dimension Weight Scenario Bridge RFC RFC 1483 R PPPoA PPPoE Configuration DefaultVC Setting PPP Service Ethernet mode PPP passwordConfiguration End address Lease Time User mode Preferred DNS Configuration TrellisWiring Misc Configuration WAN side Igmp proxy On WAN accessDMZ Host IP Dhcp Relay Support