Avalon Stoves DVS Insert EF II owner manual Mounting the Bedford Face, 4060111

12 Installation (for qualified installers only)

Face Mounting Brackets -- Arched, Metropolitan, Artisan Vict. Lace Faces

Some Arched, Artisan, Metropolitan, and Victorian Lace Faces include old brackets that will not mount to the heater (see illustration below). For these faces, make sure to use the new mounting brackets (either included with the heater or available through your dealer - SKU 225-20055).

WARNING: When attaching the Victorian Lace Face, tightening the screws may damage the face – simply

do not over-tighten the screws. Over- tighten the screws until they contact the face.

Old Arched,	Old Victorian	New
Metropolitan, or	Lace	Bracket
Artisan Bracket	Bracket

NOTE: The brackets

install with this pair of

closely spaced flanges

at the top.

Install the face mounting

brackets to the heater with the

included nuts.

NOTE: The face attaches to the brackets with the screws included with the face – see the instructions included with the face.

Mounting the Bedford Face

Some Bedford Faces include old brackets that will not mount to the heater. For these faces, make sure to use the new DVS Insert EF II Face Upgrade Kit (either included with the face or available through your dealer - SKU 250- 00029). The kit lowers the face and surround panels 1-1/4”. This means you must install this with a raised fireplace or raise the insert 1-1/4” above the hearth. To do this you may extend the leveling bolts or place bricks or other non- combustible under the insert.

1-1/4”

© Travis Industries 4060111 100-01175