Installation (for qualified installers only) | 15 |
Vent Restrictor
WARNING: Restrictor adjustment should only be done by a qualified installer.
Only those installations determined to be
Adjustment
Plate
Adjustment
Bracket
To Access the Restrictor: | WARNING: Use a glove to protect |
Remove the face. | your hand from burns. |
To Adjust the Restrictor:
1Determine a restrictor position. Start low (move the restrictor a maximum two positions at a time) and thoroughly test the heater before adjusting further.
2Lift up the adjustment plate and move it so the correct notch falls into the slot on the adjustment bracket.
#4 #5 #6
#3
#2
#1
This restrictor is in position 1 (factory setting).
To adjust, lift up on the | This restrictor is in |
adjustment plate and push it back | position 2. |
(use pliers if necessary). |
|
Vent Installation
Exhaust (3”) | Inlet (3”) |
3” dia. Gas Liner
Termination Cap
(Simpson Part # 991)
Inlet
Exhaust
Use
Alternative Method: use
Use
Alternative Method: use
© Travis Industries | 4060111 |