Installation (for qualified installers only) | 17 |
Vent Connector Removal and Installation
•The vent connector is shipped attached to the insert, but may be removed to facilitate tight installations. See the directions below for installation.
1.Route the flex vent through the chimney from above (leave an extra 3' at the top). Make sure the flex is thoroughly stretched.
2.Remove the vent connector and attach it to the flex vent (see the instructions on the following page). NOTE: be careful of the
3.Pull on the flex vent until the vent connector is at the same height as the insert. Temporarily attach the flex vent to the top of the chimney (leave extra slack).
4.Slide the insert into place, guiding the vent connector into the guides on top of the insert.
5.Attach the vent connector to the appliance (see the following page for details).
6.Remove any excess slack in the flex line and attach the vent termination.
1 |
2 |
2 |
3
6
5 |
4 |
© Travis Industries | 4060111 |
