Operation27
Before You Begin
•Read this entire manual before you use your new heater (especially the section "Safety Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or even death.
Location of Controls
The Pilot Flame can be
found below the back log.
An instruction card for |
|
operating the fireplace is | Open the |
attached to the inside of the | access door |
fireplace here. Replace it for | to view the |
controls. | |
easy reference. |
|
Gas Control Valve
PILOT
IGNITER
Gas Control Knob Flame Adjust Knob
| N | |
| O | |
| F | |
| F | |
| O | |
| ON/OFF Switch is | |
| located either on | |
OFF HI | the upper right of | |
the surround panels | ||
LO | or behind the | |
access panel | ||
|
Blower Knob is located either on the upper right of the surround panels or behind the access panel
Blower Knob | This knob controls the speed of the internal convection blower that |
| pushes the heated air into the room. |
On/Off Switch | This control is used to turn the heater on and off. |
Pilot Igniter | The pilot igniter is used only to start the pilot. When pressed, it sends an |
| electrical charge to the pilot assembly. This creates a blue spark |
| directly next to the pilot, igniting the pilot flame. |
Gas Control Knob | This knob is used to control gas to the heater and for starting the pilot. |
| There are three positions, ON, OFF, & PILOT. The pointer to the left of |
| the knob indicates the position this knob is in. |
Flame Adjust Knob | This knob controls the flame height from low ("LO") to high ("HI"). The |
| pointer above the knob points to the position this knob is in. |
© Travis Industries | 4060111 |
