26 | Finalizing the Installation |
FINE TUNING THE EMBER-FYRE™ BURNER
Each installation is affected by altitude, vent configuration, and fuel quality. Because of this, the restrictor and air shutter may need to be fine tuned to each installation. Follow the hints below to fine- tune the burner for optimum performance and aesthetics.
Restrictor Adjustment:
Only those installations determined to be
Air Shutter Hints:
•For more glow, open the air shutter, however, this will make the flames more blue.
•For yellow flames, close the air shutter, however, this may create less glow.
Correct | Lifting Flames | Ghosting Flames | Flickering Flames |
| Burner Ports |
|
|
Burner | (holes) |
|
|
The flames should burn right off the top of the burner ports (if they are too blue, adjust the air control).
Lifting flames indicate insufficient draft (restrictor is set too high).
Ghosting flames indicate | Flickering, short flames |
insufficient air (restrictor set too | indicate excessive draft |
high, air shutter shut down, or | (move air shutter to a higher |
other venting error). | position). |
Warning: If the vent configuration is installed incorrectly the vent may cause the flames inside the heater to lift or “ghost” – a dangerous situation. Inspect the flames after installation to insure proper performance. If the vent configuration is correct, yet the flames are lifting or ghosting, shut off gas to the heater and contact the dealer for information on remedying the problem.
8.Replace the glass.
9.Attach the face following the directions included with the face.
NOTE: If using a Rosario or Discovery face you may wish to modify the face connector (see page 11 for details).
NOTE: If using the Arched, Artisan, Metropolitan, or Victorian Lace Face you must use the face mounting brackets included with the heater (see page 12 for details).
10.Turn the flame adjust knob to its highest position - the flames should not contact the top of the firebox. Check the flame on low position. The flames should burn off of each burner hole. If the heater does not work correctly, contact your dealer for a remedy.
11.Give this manual to the home owner and fully explain the operation of this heater.
© Travis Industries | 4060111 |
