20 | Installation (for qualified installers only) |
Installation of the On/Off Switch and Rheostat
The on/off switch and rheostat may be installed in either the surround panels or control panel. See the illustration below for installation details.
WARNING:
Make sure the heater
is unpluged before
Upper Right of Trim | Control Panel |
(preferred) | (next to gas control valve) |
installing the rheostat.
Disconnect the red and brown wires leading to the on/off switch.
a Insert the wires through the rectangular mounting hole (on the
surround panel or control panel) and attach to the on/off switch.
The wires must attach to the top and bottom posts on one side of
the switch - it does not matter which wire is on top. Press the
switch into the rectangular hole until it locks into place.
Remove the knob and nut from the rheostat. Insert the
b
shaft on the rheostat through the circular hole (on the
surround panel or control panel). Secure with the nut.
| Replace the knob. |
c | Make sure the wires do not contact the burner pan or |
|
other hot surfaces (secure with lock ties if necessary).
Installation Without Surround Panels
The insert may be installed without surround panels. Mount the on/off switch and rheostat to the control panel under the burner pan (see “ Installation of the On/Off Switch and Rheostat” on page 20).
Electrical Connection
•Route the power cord out of the access hole on the right side of the appliance.
•Plug the power cord into a grounded 120 Volt outlet (do not remove the grounding pin).
•The electrical connection may also be made using the optional Wiring Kit (SKU 97200315).
© Travis Industries | 4060111 |
