Avalon Stoves DVS Insert EF II Optional Equipment for qualified installers only, 4060111

Optional Equipment (for qualified installers only) 39

5Install the logs and embers.

6Replace glass and face.

7Remove the regulator from the front of the gas control valve. Replace with the propane regulator, using the new gasket and screws included with the regulator. NOTE:

Leak test this area after the heater is installed, gas is connected, and the main burner is lit.

a

Remove and discard the three screws using a slotted screwdriver of Torx T-20.

Slotted

Screwdriver

(or T-20 Torx)

c

Install the LP regulator. Use the screws included with the LP regulator. Tighten to approximately 25 Lbs. torque.

Slotted

Screwdriver

(or T-20 Torx)

b

Remove and discard the regulator, diaphram, spring and center post.

NOTE: Make sure the regulator gasket is correctly aligned before installation.

d

Place the LP label on the base near the gas control valve.

8Make the gas line connection, bleed the gas line (if applicable), start the heater and thoroughly leak-test all gas connections and the gas control valve. Check the pilot. Adjust if necessary.

WARNING:	When lighting or re-lighting the pilot, the glass must be removed (see page 21).
To adjust the pilot flame, turn this screw (NOTE: if totally			The pilot flame must contact the thermocouple and
unscrewed gas will come out of this port). Clockwise			thermopile (see the illustration below). Adjust the pilot up or
lowers the flame while counter-clockwise raises it.		Standard	down as necessary.
		Screwdriver

© Travis Industries 4060111 100-01175