Avalon Stoves DVS Insert EF II Top Convection Deflector, Fireplace Requirements, 4060111

8 Installation (for qualified installers only)

Top Convection Deflector

Install the top convection deflector as shown to the right.

The deflector is shipped on top of the insert. The screws are shipped inside the owner's pack.

Fireplace Requirements

•Insert must be placed within a code-conforming masonry fireplace or tested and listed factory- built (metal) wood-burning fireplace. Repair any fireplace damage prior to installation.

•Because the insert uses a circulation blower, clean the fireplace, smoke shelf, and chimney prior to installation.

•This heater may be placed in a bedroom. Please be aware of the large amount of heat this appliance produces when determining a location.

For tight fits (under 24") see the section "Removing the

Vent Connector"

Min. 26-1/2"- additional space may be required for gas line installation.

Min. 19-1/2"

Attach the "This fireplace has been altered..." plate to the fireplace (use two screws or other suitable

method). You may wish to place it in a location

where it will be covered by the surround panels.

The DVS inserts 15-1/8" into the

fireplace.

See "Leveling Bolts" for details

on leveling the heater.

The gas line and shutoff

valve should be installed

prior to insert placement.

© Travis Industries 4060111 100-01175