Optional Equipment (for qualified installers only) | 37 |
LP Conversion Instructions
Install the conversion kit prior to installing the gas line to ensure proper gas use.
1Remove the glass (see page 21). Remove the logs and coals (if installed - page 23)
2Remove the burner (see illustration below).
WARNING: Do not disassemble the burner – screws on the burner must be left in place.
Lift the pilot hood off a the pilot assembly
(you may need to pull hard to remove).
c Lift the left side of the burner slightly, then slide it to the left and lift it upwards (lift the burner from below).
WARNING:
The burner is fragile - handle it with care.
Burner Replacement:
Make sure the burner is fully
b
Remove the firebox floor.
Make sure the bolt head on
d
Pull the burner forward, out of the firebox.
Replace the pilot hood
seated. When in place, the pilot
the bottom of the burner
after replacing the burner.
flame must align directly above the
burner holes.
inserts into this hole.
Orifice
Slide the air shutter all the way to the right before installing the burner.
Make sure the mixing tube slides onto the orifice.
Mixing Tube
NOTE:
Make sure the burner is fully seated. When in place, the pilot flame must align directly above the burner holes.
© Travis Industries | 4060111 |