Local Administrative Options
34 4600 Series IP Telephone Release 2.2 Installation Guide
!
CAUTION:
CAUTION: Perform these procedures only if instructed to do so by the system or LAN
administrator.
Static administration of these options causes upgrades to work differently than if
they are administered dynamically. Values assigned to options in static
administration are not changed by upgrade scripts. These values remain active
for the telephone until either:
Aside from SSON, use these option-setting procedures only with static addressing
and, as always, only if instructed by the system or LAN administrator. Aside from
SSON, do not use these option-setting procedures if you are using DHCP. DHCP is
the Dynamic Addressing Process, as indicated in Dynamic Addressing Processon
page 27.
Entering Data for Administrative Options
This section applies to all IP telephones with a display. It does not apply to the 4601 IP
Telephone, which does not have a display. This section describes how to enter data for
administrative options.
1. Invoke all local procedures by pressing the Hold or Mute button, up to 7 numeric dial pad
buttons, and the # button. The 4630/4630SW IP Telephones and the 4690 IP Conference
Telephone do not have a dedicated Hold button. On these phones, you must use the Mute
button to access these options.
A 6-second timeout is in effect between button presses after pressing the Hold button. If
you do not press a valid button within 6 seconds of pressing the previous button, the
collected digits are discarded. In this case, no administrative option is invoked.
2. Attempts to enter invalid data are rejected, and the phone emits an error beep.
3. If you enter a numeric digit for a value or for an IP address or subnet mask field after
entering only a zero, the new digit replaces the zero.
4. Press the # button to go to the next step.
●a new boot file is downloaded, or
●the IP telephone is reset, as indicated in Reset System Valueson page 51.