47
NOTE ?
In the above or below tests, you can stop the scrolling data by holding down either
“Up” or “Down” button.
PORT 1 TEST
Sending and receiving data performance can be analyzed under the PORT 1 TEST sub-menu. Press the “Up” or
“Down” button to move the cursor to “PORT 1 TEST” and press “Set”. The following sub-menu will appear:
Figure 77: PORT 1 TEST Sub-Menu
RECEIVE [ RX ] TEST
The purpose of this test is to determine that if VSI-Pro is receiving the data or not. Press the “Up” or “Down” button to
move the cursor to “RECEIVE [ RX ] TEST”. The following display will appear (example only):
Receiving data will be appear in three sperate lines, scrolling from right to left. The first line is the actual ASCII data
coming from the register while last two lines are HEX conversion of ASCII data. If you do not receive any data, check
the connections between VSI-Pro and Register or any additional interfacing device.
Press “Set” to return to the previous menu.
RECEIVE [ RX ] TEST
TRANSMIT [ TX ] TEST
RX/TX TEST
BAUD RATE SCAN
EXIT
Figure 78: RECEIVE [ RX ] TEST Display
RX BAUDRATE : AUTO
TX BAUDRATE : 2400
PARITY : NONE
DATA BIT : 8
HANDSHAKING : OFF
RECEIVING :
BAUDRATE DETECTION..
PROGRAMMING
VSI-Pro Max POS / Cash Register Interface

5.9 TEST/DEMO MODE

The TEST/DEMO MODE provides you with several ways to test the VSI-Pro and demonstrate its capabilities as a
cash register interface. Press the “Up” or “Down” button to move the cursor to “TEST/DEMO MODE” and press “Set”.
The following sub-menu will appear:
Figure 76: TEST/DEMO MODE Sub-Menu
PORT 1 TEST
DATA CAPTURE
REGISTER DEMO
VERSION ID
EXIT