Setting the Command Escape Character

1. This option allows you to set or view the Command Escape Character (CEC).

2. Run-time messages from the radio begin with the CEC and the default is the pound sign (#), which has a decimal value of 35. You may need to change the default CEC character if it conflicts with other data, because an unexpected operation could occur. The range is a decimal value between 1 and 255.

3. From the Configure menu, select Escape.

Escape Char + 35

E R +

Use A as shown in the following table:

E

R

+

Press A to

Press A to

Press A to

 

 

 

Saves the setting

Scrolls through the positions

Increments the current position

 

from left to right

setting by 1

4. When the setting you want is displayed, press E to save the setting. You return to the Configure menu.

5. Press F to exit.

When you select “Exit” after configuring, you will see

Configure

Save Settings ?

EX

To save all the configuration settings, press E. To exit without saving the configuration settings, press X. Press F until you see “Ready.”

Note: You must reset the RF network before your changes take effect. See “Resetting the RF Network” for more information.

Printing a Network Information Label

You can print a network information label with the device name, IP address, and MAC address as a Code 128 bar code. You can also print the network information as a Code 39 bar code with the correct MIF settings.

1. Turn on the printer.

2. Press A under <T>. You see the printer’s IP address. For example, 192.0.0.192

3. Press A under to print a network information label.

Sample Label

2-8System Administrator’s Guide