SEt IP BAnner [EN/DIS]
Sets printing of LPD job banners.
SEt IP BOot n
Sets number of retries (n) for DHCP, BOOTP, RARP
SEt IP CHKSUM [EN/DIS]
Enables or disables IP receive checksum.
SEt IP FTIme [EN/DIS]
Enables or disables fast timeout.
SEt IP FTP [EN/DIS]
Selects whether to use the FTP protocol.
SEt IP HTTP [EN/DIS]
Selects whether to use the HTTP protocol.
SEt IP KEepalive n
Sets keep alive interval (n) in minutes.
SEt IP LPD [EN/DIS]
Selects whether to use the LPD protocol.
SEt IP MEthod [AUTO/BOOTP/RARP/DHCP/STATIC]
Sets method of getting IP address.
SEt IP PIng aa.bb.cc.dd
Sends IP ping packets to test the host connection.
SEt IP PRObe [EN/DIS]
Enables or disables the TCP connection probe.
SEt IP RARp flags nn
0Both
1no subnet
2no router
3neither
Default (0) - IP address is set with subnet mask and router that is the same address as host.
SEt IP RANge [EN/DIS/ALL] aa.bb.cc.dd [MAx ee.ff.gg.hh]
Sets the valid range of IP addresses.
SEt IP REtry [EN/DIS]
Enables or disables LPD retry continuation
SEt IP ROuter aa.bb.cc.dd
Sets default Router/Gateway address (or access point).
SEt IP SUbnet aa.bb.cc.dd
Sets default subnet mask.
SEt IP TCP [EN/DIS]
Selects whether to use the raw TCP (port 9100) protocol.
SEt IP TELNET [EN/DIS]
Selects whether to use the Telnet protocol.
SEt IP TFTP [EN/DIS]
Selects whether to use the TFTP protocol.
SEt IP TImeout n
Sets timeout (n) in minutes.
SEt IP TRAP n ADDR <a.b.c.d[:e]>
Sets the destination IP address and optional port number to specify where to send the trap (n). If the port is not specified, it defaults to 162.