2. Click Update Firmware.
3. The printer should be connected and ready to receive data.
To update from a TFTP server:
1. Type the TFTP Server IP address.
2. Type the relative pathname (relative to your TFTP server). Refer to your TFTP Server’s documentation for more information about setting up and using the TFTP server.
Note: Depending on your TFTP server, you may only need the filename, not the entire path.
3. Click Submit to load the firmware. If you lose power while updating the firmware, call Service.
To update from a file on your computer:
1. Type the location of the file or click Browse and select the file location.
2. Click Submit to load the firmware. If you lose power while updating the firmware, call Service.
Note: Do not turn off the printer while it is updating firmware. It may take several minutes to complete.
L o a d i n g t h e F i r m w a r e
Early versions of the software may have menus which differ slightly from those listed below.
1. Run the UpdateIP utility from the Monarch® Documentation
2. Select the update .bin file, print server, then click Update, Start.
3. If you are using TCP/IP to upgrade, select TFTP PUT from this host.
If you are upgrading using IPX/SPX on a NetWare network to upgrade, select NetWare GET from a server (If you are using NetWare to upgrade, you need to put the .bin firmware file in the LOGIN directory of the NetWare server). Click OK.
4. If you selected TFTP PUT from this host in step 3, enter the configuration password (default is access) and click Browse to find the .bin firmware file you downloaded. Click Load. The firmware on your print server will be upgraded to the new version.
If you selected NetWare GET from a server in step 3, enter the configuration password (default is access). Enter the name of the NetWare server where you saved the .bin file as the Host Name. Enter the name of the firmware file for File. Click OK. The firmware on your print server will be upgraded to the new version.
Using a Web Browser