You must
C o n t r o l l i n g I P A c c e s s
1. You can limit which remote hosts are able to access the printer by setting up an IP address range.
2. From the side menu, click Admin. The Web Admin Configuration screen appears.
3. Click Configure IP Access Control.
To Add Hosts:
You can specify the valid range of remote IP addresses.
1. Enter a range of remote IP addresses that are allowed access to the printer. Any requests from hosts outside this range are rejected.
2. Click Add.
3. Click the reset link at the bottom of the screen. The Reset Server screen appears.
4. Click Submit and wait five seconds for the print server to reset.
Even though you submitted your changes, they do not take effect until you reset the print server.
You must
5. The range of accepted IP addresses is listed in the
To Remove Hosts
You can remove a range of remote IP addresses.
1. Select a range from the
2. Click Remove.
3. Click the reset link at the bottom of the screen. The Reset Server screen appears.
4. Click Submit and wait five seconds for the print server to reset.
Even though you submitted your changes, they do not take effect until you reset the print server.
You must
C o n f i g u r i n g N e t w o r k S e c u r i t y
You can enable or disable network security, assign WEP keys, set up a User ID and password, select an authentication protocol, and more. See “Basic Security Configurations” for more information.
1. From the side menu, click Admin. The Web Admin Configuration screen appears.
2. Click Configure Network Security.
Using a Web Browser