AXIS 2100 User’s Guide | Quick Network Installation Procedure |
Quick Network Installation Procedure
Follow the instructions below to quickly install the AXIS 2100 on an Ethernet network.
If you do not have a network and intend to use a modem with your AXIS 2100, please refer to the UsingYour Camera with a Modem section of this User’s Guide.
1.Note the serial number found on the underside label of the AXIS 2100. The Ethernet address is the same as the serial number of the unit.
2.Acquire a valid and unused IP address for the AXIS 2100 from your Network Administrator.
Assign the IP address using the ARP command, as described below:
Windows 95/98 & NT/2000 only - Start a DOS window and type these commands:
Syntax: arp
Example: arp
UNIX only - Type these commands:
Syntax: arp
Example: arp
You will now see the message ‘Request timed out...’, repeatedly returned in the window.
3.Connect your AXIS 2100 to the network and external power supply.
To verify that the address has been set and that communication is established, ping the unit once again with the new IP address; the host then returns: ‘Reply from 172.21.1.200...’ or similar.
4.To access the AXIS 2100 Home Page, start the Web browser and enter the IP address in the location/address field:
Syntax: http://<IP address>/
Example: http://172.21.1.200/
5.With reference to the
Note: •If you are installing many units on to your network, please refer to the AXIS IP Installer informa- tion under the section Installing Your Camera on a Network in this User’s Guide.
