AXIS 2400/2401 Admin Manual The AXIS 2191 Audio Module 35
Using the Audio Module with Your Video Server
Your audio module is now configured and ready for use with your video server. Enter the server’s
IP-address in Internet Explorer, or click Home on the server’s admin page. You should then see the
control panel for the AXIS 2191 below the image. If no audio controls are visible, check that you
have selected the audio module for use on COM2.
Using the Different Audio Modes

Full-Duplex

Full-Duplex mode means that you can transmit and receive audio (talk and listen) at the
same time, without having to use any of the controls. This is just like having a telephone
conversation. The only controls you may wish to use are the mute checkboxes to turn off
the sound, and the level sliders, to adjust the input/ou tput levels. This mode requires a
full-duplex sound card on your computer. If your a vai la ble bandwidth is 0.2Mbit/s or less,
it is recommended that you use Half-Duplex mode instead.

Half-Duplex

Half-Duplex mode also sends and receives audio in both directions, but only in one
direction at a time. This means you must actively transmit with the help of the
Push-to-Talk button. To speak, press the button (check that the microphone is not muted).
When finished speaking, release the button. You will now be receiving audio from the
other end of the connection. Note that the Push-to-Talk button can be configured for use
in two different ways - Toggle or Instant. This is set in the server’s admin tools.
Half-Duplex mode is best if you only have limited bandwidth av ailable.
Push-To-Talk
Used in Half-Duplex or
Simplex - Talk mode.
The button’s own
mode is set in the
server’s admin pages.
Mute Checkboxes
Check to mute speaker or microphone.
NB. Exactly which controls will be
visible below the image depends
on the audio mode you are using.
For example, the Push-to-Talk
button will not be visible in
Full-Duplex mode. Similarly, when
using Simplex - Listen mode, only
the Speaker controls will be
shown. The audio mode is set in
the server’s admin tools.
Show/Hide Settings
Shows or hides the
slider controls and
level indicators.
Available Bandwidth
Select the bandwidth available
for your connection.
Level Adjust IN/OUT
Drag sliders to adjust level.