Manuals / B&B Electronics / Computer Equipment / Network Card

B&B Electronics HVD100A3 manual Byte value, Byte Function, number

Models: HVD100A3

1 31

Page 17

Byte	Byte value	Byte Function
number	(hex)
1	01	Start of frame
2	02	The number of control bytes
3	01	ID byte 01= J1708
4	10	Function code 10 hex stop receive
5	00	Number of data bytes (00 place holder)
6	14	Checksum (bytes 1 through 5 added
		together)

After sending this command to the device, the device will respond with a confirmation message and data will cease. Note that there is the possibility of an incomplete message being sent to the PC after sending this command. Use the check-sum to verify all messages.

To restart reception, send the (01, 02, 01, 11, 00, 15) command to the HDV.

HDV100A3 Command & Response Manual-1306cr

B&B Electronics -- 707 Dayton Rd. -- PO Box 1040 -- Ottawa, IL 61350

PH (815) 433-5100 -- FAX (815) 433-5104

Page 17

Image 17

B&B Electronics HVD100A3 manual Byte value, Byte Function, number

Contents

HDV100A3 Command & Response Manual-1306crCover Page HDV100A3 Command Response ProtocolModel HVD100A3 International HeadquartersPage J1708 COMMANDS Table of ContentsJ1939 COMMANDS ERROR CODESwithout a complete understanding of the operation of the network Do Not Transmit Any Messages to the networkIntelligent Mode Verification IntroductionIntelligent Mode Message Structure Intelligent Mode Command ProtocolControl Field Structure Data Field StructureFormatting the Control Bytes Command Acknowledgement Detailed Description of General Function CodesRS-232 Baud Rate Setup B&B Electronics HDV100A3 Command & Response Manual-1306cr707 Dayton Rd PO Box 1040 -- Ottawa, ILSetting Baud 1, Baud Baud Rate Setup Table Byte Baud Rate ExampleByte Byte FunctionTime Stamp Information Byte Byte Master Reset CommandByte FunctionJ1708 Commands Byte value ByteByte Function numberPriority Byte Value Transmitting Data to the J1708 BusBinary Value Hex ValueByte Value ByteByte Function NumberJ1708 Message Filter Byte Broadcast MessageByte FunctionByte 6 Priority Values Byte 4 ValuesJ1939 Commands Stop Receive on J1939 Bus Start Receive on J1939 BusJ1939 Arbitration Field Arbitration Field Y1, Y2, Y3, Y401050206C7CCED0D6780200008F07DDA00 00FFFFDAC9 Transmit Data to J1939 Bus HDV100A3 Command & Response Manual-1306crSet Mask ByteSet Filter 1 to 2. Set the “Mask” to the desired pattern 01, 06, 02, 04, XX, XX, XX, XX, 00, CS J1939 Header Worksheet Error Codes