47
| 3 |
1 | 2 |
A | B |
|
To remove the two covers for the main connection panel, first pull out, then pull down at the bottom
–also if the television is placed on a stand. To release the cover for the Smart Card and CA- module (3), press the cover to the right.
Always remove cover 1 before removing cover 2.
When you have made all the connections and fastened the cables, mount the cable covers again.
IMPORTANT! For safety reasons the mains supply cable must be fastened to the cable strip (A). All cables must be run through the cable strip (B).
However, if your setup includes a VGA connection, do not run the VGA cable through the cable strip
(B). Instead, use the two screws in the VGA plug to fasten it to the socket.
If you are going to connect any other equipment to the television, do not connect it to the mains yet!
The supplied mains cord and plug are specially designed for the television. If you change the plug or in any way damage the mains cord, it will affect the TV picture adversely!
When connections are complete and the cables have been secured as described, switch on the mains supply. A tiny, red light appears. The system is in standby mode and ready to be used.
If your television is set up on its own, you can now tune in channels as explained in the chapter
