3. Advanced Commands
Sent Data
Data[0] = bySlaveAddr1
Data[1] = bySlaveAddr2
...
Data[N-1] = bySlaveAddrN
bySlaveAddrn = byte representing the address of the module or unit to be diagnosed.
If ommited, all all the units are reported.
Unit Hex address
Motor driver \x74
Lamp driver \x78
Video processor \x96
Fpga backplane1 \xb4
Fpga backplane2 \xb6
Fpga backplane3 \xb8
ADC 9886 layer1 \x98
ADC 9887 layer1 \x9e
ADC 9887 layer2 \x9a
DVI indicators layer1 \x7e
DVI indicators layer2 \x7a
Video decoder \x42
Video indicators \x7c
Table3-286
addressoverview
Returned Data
Data[0] = strDiagnosis1
Data[1] = strDiagnosis2
...
Data[N-1] = strDiagnosisN
3.33 Panel size, Read
Description
Reads the size of the LCD panels
Command
Command [0] \xf0
Command [1] \x01
Returned Data
Data [0]...Data [3] = wpixels = unsigned word,see chapter "1. Serial communications Basics", "Data words", page 6 , representing
the number of pixels in one line.
Data [4]...Data [7] = wlines = unsigned word (2bytes), representing the number of lines.
R5976884 RLM SERIES 04/04/2006 159