Baum Bros. Imports 26.4 manual Knife Change, Mounting the knife

6.0 Knife Change

Knife Change

Mounting the knife

1.Replace cutting stick or turn same over (see page K6 - 5)

2.Turn adjusting cam (e) to the "0 - position" by means of the knife wrench

3.Screw knife handles (c1) into the black bordered bolt holes (f) of the new knife

4.Take knife out of the knife box

5.Remove knife handles (c1) and mount knife guard (c)

6.Insert the knife into the knife bar slots (b) and lift it up into the elongated holes (g; Attention! Mind the clamping resistance of the knife guard)

7.Release knife guard (knife is clamped to knife bar)

8.Screw all knife screws (except screw at the very right-hand side!) slightly into the lower bolt holes*; do not fasten them!

9.Remove knife guard

10.Slightly screw-in the remaining screws, but do not fasten them!

11.Push the knife at the center screw (h) up to its topmost position by means of the knife wrench and fasten it

Continuation next page

g

e

b

f

d

h

* See also "Knife Adjustment", page K6 - 4, item 3

K6 - 3