Belkin F1D104-OSD Scan Time, Display Time, The BANK/SCAN Button, Usage continued, 7sec, 15sec

P72895_F1D104-OSD-univ_man.qxd 7/16/01 3:24 PM Page 14

Usage (continued)

SCAN TIME:

Amount of time the OmniView™ PRO stays on one port before switching to the next port when in Scan Mode.

DISPLAY TIME:

Amount of time the OSD Menu or Port Name remains displayed on-screen after making a port selection.

SCAN TIME:
■ 7sec	■ 15sec	■ 30sec	■ 60sec
DISPLAY TIME:
■ 7sec	■ 15sec	■ 30sec	■ 60sec

[↕]: SELECT

(INS): RENAME

(Enter): COMPLETE

(Esc): Exit

NOTE: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are set on the MASTER unit only, and need not be set on the slave units.

The BANK/SCAN Button:

Pressing the BANK/SCAN button cycles you through all the active BANKs (if their slave units present) and then puts the unit in AutoScan mode. If the unit is a single MASTER unit, pressing the button immediately invokes AutoScan mode. This is evident by a long BEEP, followed by two short beeps.

14