16
USING YOUR PRO2
Powering up the Systems
Once all cables have been connected, power up the computers that are
attached to the PRO2. All computers can be powered on simultaneously. The
PRO2 emulates both a mouse and keyboard on each port and allows your
computer to boot normally.
The computer connected to port “1” will be displayed on the monitor. Check
to see that the keyboard, monitor, and mouse are working normally. Proceed
to do this with all occupied ports to verify that all computers are connected
and responding correctly. If you encounter an error, check your cable
connections for that computer and reboot. If the problem persists, please
refer to the Troubleshooting section in this manual.
Using Your PRO2:
Now that you have connected your Console and computers to your PRO2,
it is ready for use.
Select connected computers by either the direct-access port selectors, located on
the front panel of the PRO2, using the On-Screen Display, or by using hot key
commands through the Console keyboard. It takes approximately 1-2 seconds for
the video signal to refresh after switching computers. Re-synchronization of the
mouse and keyboard signals also occurs. This is normal operation and ensures
that proper synchronization is established between the Console and the con-
nected computers.