22
USING YOUR PRO2
Connecting Computers: 1. Connect a keyboard, monitor, and mouse to the computer you prepared for
firmware update. It must run Windows 95, 98, or Me.
2. Connect the power adapter to the PRO2. Be sure that all connected com-
puters are powered off at this moment.
3. Connect the custom flash cable (DB25 Male-to-RJ45; included with
purchase). Connect one end of DB25 to your computer’s parallel port
and the other end of RJ45 to the PRO2 flash upgrade jack.
Setting the PRO2 into Flash Mode:The PRO2 has four Flash DIP switches:
DIP Switch Firmware
1 2 3 4
ON OFF OFF OFF Main
OFF ON OFF OFF OSD
ON ON OFF OFF Keyboard 1
OFF OFF ON OFF Mouse 1
ON OFF ON OFF (F1DA116T Only) Keyboard 2
OFF ON ON OFF (F1DA116T Only) Mouse 2
The DIP switch should be set to the specified settings when you are
attempting to update a particular firmware. For example, set DIP switch 1 to
“ON” to flash update the main firmware of the switch.
Note: F1DA116T requires that you flash update two firmwares for the mouse
and keyboard, separately.
1. Once the above steps have been completed, run the Flash software exe-
cutable. Make sure that the appropriate Flash DIP switch is set to the “on”
position. Only one firmware can be flashed at one time.
2. After the Flash update has been completed unplug the power supply from
the PRO2.
3. Set all DIP switches to the Off position.
4. You are now ready to use your PRO2 or continue flashing a different
component if necessary.