Belkin F1DP116Gea, F1DP108Gea Video Configuration and Settings, Refresh, Manual Video Adjust

Using the Switch from a Remote Console

Video Configuration and Settings

Refresh

You may need to refresh the video image when changing the display attributes of a target server.

To refresh the video settings:

1.In the quick-access toolbar, click

2.Select “Refresh” or press “Crl+R”.

Manual Video Adjust

You may want to manually adjust video to fine-tune the target-server video settings, to adapt to a noisy environment or a non-standard VGA signal, or when using a full-screen DOS/CLI mode.

To adjust the video manually:

1.In the quick-access toolbar, click

2.Select “Manual video adjust”. A slider bar will appear (see Fig. 18). A red frame will also appear around the screen. This represents the screen area according to the server’s screen resolution.

3.Move the sliders to adjust and change the displayed image. Click in the area of the sliders for fine-tuning.

•Brightness/Contrast —adjusts the brightness and contrast of the displayed image

•Horizontal Offset —defines the starting position of each line on the displayed image

•Vertical Offset—defines the vertical starting position of the display image

•Phase—defines the point at which each pixel is sampled

•Noise Level—represents the video noise when a static screen is displayed

•Automated Adjust—when this box is checked, the video adjusts automatically whenever there is a change in the screen resolution.

52