English

Personalizing the projector menu display

The On-Screen Display (OSD) menus can be set according to your preferences. The following settings do not affect the projection settings, operation, or performance.

Rename User Mode: See "Renaming user modes" on page 27 for details.

Menu Display Time in the System Setup > Menu Settings menu sets the length of time the OSD will remain active after your last key press. The time length ranges from 5 to 30 seconds in 5-second increments. Use / to select a suitable time length.

Menu Position in the System Setup > Menu Settings menu sets the OSD position in five locations. Use

/ to select a preferred position.

Language in the System Setup menu sets your familiar language for the On-Screen (OSD) Menus. See "Using the menus" on page 22 for details.

Splash Screen in the System Setup menu sets a preferred logo screen to be displayed during projector start-up.

Locking control keys

With the control keys on the remote control and projector locked, you can prevent your projector settings from being changed accidentally (by children, for example). When Key Lock is on, no control keys on the remote control and projector will operate except POWER ON/OFF and EXIT.

To lock the keys:

1.Press MENU and then press / until the Advanced Setup menu is highlighted.

2.Press to highlight Key Lock, and press ENTER. The control keys lock.

To unlock the keys, press and hold EXIT on the projector or remote control for 5 seconds.

Advanced Setup

Lamp Settings

HDMI Settings

 

Baud Rate

115200

Test Pattern

 

High Altitude Mode

Off

Password

 

Key Lock

ENTER

Reset All Settings

 

ISF

 

S-Video

EXIT Back

Turning the projector off

To turn the projector off, press POWER OFF on the remote control to turn the projector off directly. Or you can press II on the projector and a warning message appears. Press II again.

The Power indicator light flashes orange and the fans run for about two minutes to cool the lamp. The projector will not respond to any commands until the cooling process is complete.

Then, the Power indicator light is a steady orange once the cooling process has finished and fans stop.

If the projector will not be used for an extended period, unplug the power cable from the power outlet.

To protect the lamp, the projector will not respond to any commands during the cooling process.

Power Off

Press button again to power off.

Press any other button to cancel

36 Using the projector

Page 36
Image 36
BenQ W6500 Personalizing the projector menu display, Locking control keys, Turning the projector off, To lock the keys