![](/images/new-backgrounds/1103569/103569203x1.webp)
Chapter 7: Command-Line Management
3.Command Syntax: restore default
4.Example:
The following example restores the default setting of the switch: switch_a#restore default
switch_a# Auto Save:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen. switch_a(config)#
2. Usage:
Use this command to enable auto save configuration function. The configuration will automatically be saved at every configured interval when this command is enabled. Use the no form of this command to disable this feature.
3.Command Syntax: service
4.Example:
The following example enables or disables auto save the configuration to the switch: switch_a(config)#service
switch_a(config)#no service
Auto Save Interval
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen. switch_a(config)#
2. Usage:
Use this command to set the interval when the configuration will automatically be saved. The range of interval value is from 5 to 65535. The default value is 30 seconds.
3. Command Syntax:
service
Page 102 |