![](/images/new-backgrounds/1103569/103569387x1.webp)
Chapter 7: Command-Line Management
3. Command Syntax:
set port gmrp enable disable all IF_NAME enable Enable GMRP on
4. Example:
The following example enables GMRP on interface fe1 (port 1): switch_a(config)#set port gmrp enable fe1 switch_a(config)#
The following example enables GMRP on all ports: switch_a(config)#set port gmrp enable all switch_a(config)#
GMRP Registration:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen. switch_a(config)#
2. Usage:
Use this command to set GMRP registration type for all ports for a given bridge.
3. Command Syntax:
set gmrp registration normal fixed forbidden IF_NAME
normal Specify dynamic GMRP multicast registration and deregistration on the port.
fixed Specify the multicast groups currently registered on the switch are applied to the port, but any subsequent registrations or deregistrations do not affect the port. Any registered multicast groups on the port are not deregistered based on the GARP timers.
forbidden Specify that all GMRP multicasts are deregistered, and prevent any further GMRP multicast registration on the port. IF_NAME Defines a text string used as the name of the interface; ASCII string from 1 to 16 characters.
4. Example:
The following example sets interface fe1 (port 1) to normal registration: switch_a(config)#set gmrp registration normal fe1 switch_a(config)#
GMRP Forward All:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
Page 194 |