![](/images/new-backgrounds/1103569/103569353x1.webp)
Chapter 7: Command-Line Management
4. Example:
The following example sets Link Layer Discovery Protocol (LLDP) Link Aggregation Type Length Value (TLV): switch_a(config)#lldp
switch_a(config)#
LLDP Ports Settings
Transmit:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
2. Usage:
Use this command to send Link Layer Discovery Protocol (LLDP) packets on the interface.
Use the no parameter with this command to disallow sending Link Layer Discovery Protocol (LLDP) packets on the interface.
3.Command Syntax: (no) lldp
4.Example:
The following example sends Link Layer Discovery Protocol (LLDP) packets on the interface fe1 (port 1): switch_a(config)#interface fe1
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
2. Usage:
Use this command to receive Link Layer Discovery Protocol (LLDP) packets on the interface.
Use the no parameter with this command to disallow receiving Link Layer Discovery Protocol (LLDP) packets on the interface.
Page 177 |