![](/images/new-backgrounds/1103569/103569305x1.webp)
Chapter 7: Command-Line Management
fe1 means port 1.
The
2. Usage:
Use this command to enable or disable the BPDU Guard feature on a port.
Use the no parameter with this command to set the BPDU Guard feature on a port to default.
This command supersedes the bridge level configuration for the BPDU Guard feature. When the enable or disable parameter is used with this command, this configuration takes precedence over bridge configuration. However, when the default parameter is used with this command, the bridge level
3. Command Syntax:
4. Example:
The following example enables the BPDU Guard feature on the interface fe1 (port 1): switch_a(config)#interface fe1
7.8 VLAN
VLAN Mode Setting, 802.1Q VLAN Setting, 802.1Q Port Setting, Port Based VLAN
802.1Q VLAN Setting
VLAN Database:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen. switch_a(config)#
2. Usage:
Use vlan database command to enter the VLAN configuration mode.
3.Command Syntax: vlan database
4.Example:
The following example changes to VLAN configuration mode from Configure mode: switch_a(config)#vlan database
Page 153 |