![](/images/new-backgrounds/1103569/103569299x1.webp)
Chapter 7: Command-Line Management
2. Usage:
Use this command to enable Storm Control (broadcast and multicast) for Chain Protocol setting. Use the no form of the com- mand to disable Storm Control (broadcast and multicast) for Chain Protocol setting.
3. Command Syntax:
bridge GROUP
Group =
4. Example:
The following example enables chain storm control for bridge GROUP (1): switch_a(config)#bridge 1
Chain Pass-Through Setting
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen. switch_a(config)#
2. Usage:
Use this command to set chain
3. Command Syntax:
chain
IFNAME Chain
IFNAME Chain
4. Example:
The following example enables the fe3 and fe4 as chain
switch_a(config)#
Advanced Setting
Advanced Bridge Configuration:
Bridge
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen. switch_a(config)#
Page 150 |