![](/images/new-backgrounds/1103569/103569271x1.webp)
Chapter 7: Command-Line Management
2. Usage:
Use this command to enable the Spanning Tree protocol on a bridge.
Use the no form of the command to disable the Spanning Tree protocol on a bridge.
3. Command Syntax:
bridge GROUP
no bridge GROUP
4. Example:
The following example enables or disables the
switch_a(config)#no bridge 1
Bridge Priority (0..61440):
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen. switch_a(config)#
2. Usage:
Use this command to set bridge priority for the common instance. Using a lower priority indicates a greater likelihood of the bridge becoming root.
3. Command Syntax:
bridge GROUP priority PRIORITY no bridge GROUP priority
GROUP
PRIORITY
4. Example:
The following example sets the priority PRIORITY (4096) of bridge GROUP (1): switch_a(config)#bridge 1 priority 4096
switch_a(config)# Hello Time (sec) (1..9):
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen. switch_a(config)#
Page 136 |