![](/images/new-backgrounds/1103569/103569317x1.webp)
Chapter 7: Command-Line Management
Port Based VLAN
Switchport portbase add/remove vlan:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
2. Usage:
Use this command to set or remove the default VLAN for the interface.
3. Command Syntax:
switchport portbase add|remove vlan VLANID
VLANID The ID of the VLAN will be added to or removed from the
4. Example:
The following example specifies to add the interface fe1 (port 1) to VLANID (2): switch_a(config)#interface fe1
7.9 QoS
Global Configuration, 802.1p Priority, DSCP
Global Configuration
QoS:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)# prompt will show on the screen. switch_a(config)#
2. Usage:
Use mls qos enable command to globally enable QoS.
Use the no mls qos command to globally disable QoS.
3.Command Syntax: mls qos enable (no) mls qos
Page 159 |