Black Box MC200A Fax Configuration Utility, Copyright  2006 Ringdale User Manual, Page 12 of

Configuration

The complete configuration can be done with any Telnet client, like HyperTerminal or simply using the Windows Command prompt “telnet”. This will work on any FaxReceiver that is on the same virtual network.

Black Box has provided a FaxConfig utility that allows you to perform the basic IP configuration of any FaxReceiver that is on the same physical network.

These are the steps necessary to configure the FaxReceiver using the Windows command prompt telnet client.

FAX CONFIGURATION UTILITY

There is a FaxConfig utility on the CDROM in the Fax Configure Tool directory of the CDROM. You can run this utility from the CDROM or drag it to your PC.

NOTE: The FaxConfig utility will only communicate properly with devices on its local network or on 11.22.33.44.

1)Double-click on the FaxConfig utility to start it. It will bring up the following screen:

2)If it does not see the FaxReceiver, check the connections and power, and then

click on the Requery Network button. If changes were made using Telnet, you should click on the Requery Network button. If you have connected the FaxReceiver since starting FaxConfig utility, use the Requery Network button to discover it.

Copyright  2006 Ringdale User Manual, 62-15820000 Page 12 of 49