Abandoning Changes, Changing the Configuration | Black Box RMU200

G-Converter Chassis

Abandoning Changes

Pressing ESC at any point before a configuration is updated will cause the message “Abandon Changes? (y/n)” to appear at the bottom of the screen. If “n” is selected, the message will disappear and editing may continue. If “y” is pressed, all modifications will be abandoned and the last updated configuration will be re-printed on the screen.

Changing the Configuration Page

The Configuration Page required, e.g. “Alarms”, is selected by moving the cursor to the upper right area and pressing Enter when alongside the required page. The currently selected page is indicated by a ‘*’.

Restoring the Factory Default Configuration

The system may be reset to the factory default configuration by pressing CTRL-Rfour times when the cursor is on the Terminal emulation page (see page 12). A ‘Confirm’ message will be displayed before the configuration is reset. The previous configuration will be lost.

TECHNICAL: 0118 931 2233 15

Image 15

Black Box RMU200 manual Abandoning Changes, Changing the Configuration, Restoring the Factory Default Configuration

Contents

Converter Chassis Converter Chassis Converter Chassis Contents Converter Chassis Converter System’s Chassis Overview Introduction Manager Card Power Supplies Manager Card LED IndicationRemoval of Manager Card Channel Cards InstallationEnvironmental Considerations Card Cage System Management Overview Supervisor Port terminal management Supervisor Terminal RequirementsSupervisor Terminal Emulation General set-up Display Layout Typical Configuration Display Parameter Changing Accepting all changes and Updating the ConfigurationGeneral Keyboard Conventions Cursor Movement Changing the Configuration Restoring the Factory Default ConfigurationAbandoning Changes Base-T Port Telnet Management Supervisor Terminal Requirements Typical Configuration Display General Keyboard Conventions Telnet Screen Ethernet Screen IP Screen Alarms Screen Events Screen Snmp Management Configuration Sales 0118 965 Typical Configuration Display General Keyboard Conventions Abandoning Changes Snmp Traps DiagnosticsPower Supply Fan Assembly Appendix A- Warnings Installation of Equipment Converter Chassis 703/G.704 Appendix B -Approval Requirements Appendix C EMC Requirements DCD