G-Converter Chassis
TECHNICAL: 0118 931 2233
Appendix A- Warnings WARNING: This unit is a Class one product and thus relies on the protective earth in
the 230volt-AC power mains leads. Under no circumstances must the
unit be operated with this earth disconnected.
INSTALLATION OF EQUIPMENT
WARNING: Installation of this equipment must only be performed by suitably trained
service personnel.
This equipment allows connection only of suitable equipment to its ports,
the safety status of which are defined below.
SELV Ports:
i) 10BaseT
ii) Supervisor
The above named ports are classified as SELV (Safety Extra Low
Voltage) in accordance with in Clause 2.3 of EN60950 (BS7002, IEC950
as applicable), and must only be connected to equipment which similarly
complies with the SELV safety classification.
Fire/Electrical enclosure
WARNING: To comply with the requirements of EN60950 the Card Cage System
must be located in a suitable cabinet complying with the requirements of
EN60950 for a fire and electrical enclosure.
Non ‘hot swap’ components.
WARNING: The Card Cage System has the ability to have certain cards removed
whilst the unit is powered up and operating. These cards are;
i) Manager Card front.
ii) Data Channel Cards front and rear
iii) Power Supplies front
The Power Supply rear panel that accommodates the mains inlet
connectors, fan, 10Base-T RJ45 and Supervisor D-type must under
no circumstances be removed.