20
G-Converter Chassis SALES: 0118 965 5100
Abandoning Changes
Pressing ESC at any point before a configuration is updated will cause the message
“Abandon Changes? (y/n)” to appear at the bottom of the screen. If “n” is selected the
message will disappear and editing may continue. If “y” is pressed, all modifications will be
abandoned and the last updated configuration will be re-printed on the screen.
Changing the Configuration Page
The Configuration Page required, e.g. “Alarms”, is selected by moving the cursor to the
upper right area and pressing Enter when alongside the required page. The currently
selected page is indicated by a ‘*’.
Restoring the Factory Default Configuration
The system may be reset back to the factory default configuration by pressing CTRL-R four
times when the cursor is on the Terminal emulation page (see page 12). A ‘Confirm’ message
will be displayed before the configuration is reset. The previous configuration will be lost.
Telnet Screen
The Telnet screen allows Telnet specific parameters to be set.
Set password Telnet password (Blank = no password)
TCP Port TCP port being used (Read only)