Listening to Recorded Messages | Bogen LUMDMU specification

Listening to Recorded Messages

NOTE: Use the front panel handset to listen to messages.

As the message plays into the handset, the display counts down the message time.

1		Press the FUNC button until the display indicates
		monitor.

				MONITOR


	2	Press the RUN button to select the message number.

				MSG-01


	3	Press the FUNC key until the desired message
		number appears.


				MSG-11


	4	Press RUN to listen to the message.

mm:ss

Length of message.

DONE

Done playing message.

9

Image 12

Bogen LUMDMU manual Listening to Recorded Messages

Contents

Multiple Digital Message Unit Domestic and International Approvals Table of Contents Introduction Before You Start Installation Steps Have Required Tools Connect the Mdmu to the Telephone System Rack Mounted Mdmu Mdmu Connection to Over Ride Set the Mdmu options on the DIP switch. Refer to Table below Power Up System Push the Battery slide switch to the on position Controls and Indicators Front Panel OperationRecording Messages When recording is complete, press the Func key Listening to Recorded Messages Playing Messages Press the Func button until Play is displayedPress the RUN button Than MSG-01 to play You are configured for 8 see Playing Messages in SequencePress the Func button to select a message other Press RUN to play and group the message Adding a Time Delay Between Message Plays Clearing a Message Sequence Press RUN to clear the message sequence Checking Message Times Press the Func button until Time appears Reset Delay Times to Default Audio and Memory Tests Button to end the continuous audio TestButton until Test appears Button to select the memory test Telephone Access Operation Playing Messages Specifications On the next page give the Aux. Connector pin-out definitions PIN Wire Colors Definition Blue White J1 Ring Orange