Checking Message Times | Bogen LUMDMU specification

Checking Message Times

The TIME function displays the time used for each message recorded. It also displays the remaining time available in system memory to record other messages.

1

2

Press the FUNC button until TIME appears.

TIME

Press the RUN button (once) to view message numbers and recording time.

MSG-01

Message number.

mm:ss

Time used to record message in minutes and seconds.

3 Once all messages and times are displayed, the display indicates:

LEFT

Amount of time left on the system to record other messages.

2:09

Available MDMU memory time in minutes and seconds.

DONE

14

Image 17

Bogen LUMDMU manual Checking Message Times, Press the Func button until Time appears

Contents

Multiple Digital Message Unit Domestic and International Approvals Table of Contents Before You Start Introduction Have Required Tools Installation Steps Rack Mounted Mdmu Connect the Mdmu to the Telephone System Mdmu Connection to Over Ride Table below Set the Mdmu options on the DIP switch. Refer to Push the Battery slide switch to the on position Power Up System Recording Messages Controls and IndicatorsFront Panel Operation When recording is complete, press the Func key Listening to Recorded Messages Press the Func button until Play is displayed Playing MessagesPress the RUN button Than MSG-01 to play Playing Messages in Sequence You are configured for 8 seePress the Func button to select a message other Press RUN to play and group the message Adding a Time Delay Between Message Plays Press RUN to clear the message sequence Clearing a Message Sequence Press the Func button until Time appears Checking Message Times Audio and Memory Tests Reset Delay Times to Default Test Button to end the continuous audioButton until Test appears Button to select the memory test Telephone Access Operation Playing Messages On the next page give the Aux. Connector pin-out definitions Specifications PIN Wire Colors Definition Blue White J1 Ring Orange